Repair / Help Forum > Repair / Help

Yamaha Speaker troubleshooting

(1/1)

sean283:
Hi Folks, it's been awhile.
Life is settling down at last and I have time to play with audio again.

So, years ago Tom hooked me up with a pair of Yamaha NS-690II speakers.
Love those things and I've been waiting for another pair to surface.
All the ones I've seen are always 1000 miles away and very expensive. 

The other day, I snatched up a rather beat up and inexpensive pair.
Work? Of course, not. When a seller says "sounds great", just assume it doesn't work.

You get what you pay for right? Anyway, one of the mids isn't working.

I put a meter on the voice coil and it is showing continuity and reading about 3 ohms or so. So, the voice coil isn't open.
I metered out the L-pad for the mid and it appears to be working (0 to around 7 ohms).

So, I guess that leaves the crossover.
do you think a crossover cap failed open? Or?

Comments? Suggestions?
 

SunnyDaze:
Did you measure the DCR of the overall speaker at the terminals?

What is the impedance of the midrange driver? 4 Ohm, I'm assuming?

AdamG:
Since you have a pair, and one works and the other doesn't you have the perfect testing dummy to work off of. See what matches between the two and what doesn't match. There may be a lifted trace on the crossover if it uses a board or it may be a cap that has dried out entirely some how.

Dicky:
Not that it means much, but the last few bad crossovers I came across you could visually see that they were bad (burn marks, etc). 

Reverend:
Good to see you're still alive Sean!

Navigation

[0] Message Index