« previous next »
Pages: [1]   Go Down

Author Topic: 3 way crossover with 2 speakers  (Read 3385 times)

Offline scorpio333

  • Ready For Intervention!
  • ******
  • Posts: 1182
  • Karma: +0/-0
  • got mule?
3 way crossover with 2 speakers
« on: September 12, 2015, 11:07:28 PM »
Brainstorming an idea for a small project. In a typical speaker with tweeter, mid, woofer...is it ok to use just the tweeter and mid? I would cap off the leads to the woofer.
Logged

Offline Sir Thrift-a-Lot

  • Ready For Intervention!
  • ******
  • Posts: 3813
  • Karma: +1/-0
Re: 3 way crossover with 2 speakers
« Reply #1 on: September 13, 2015, 04:39:12 AM »
I think you would put a resistor of the same value as the woofer across the leads.
Logged

Offline ataudio

  • Double Secret Probation!
  • **
  • Posts: 215
  • Karma: +0/-0
Re: 3 way crossover with 2 speakers
« Reply #2 on: September 17, 2015, 09:42:47 PM »
Yes. You can do that.  Just leave the woofer leads disconnected.  Usually the woofer impedance determines the over all speaker impedance so I'm not sure what your amp will see (8 ohms, 4 ohms, etc) but I highly doubt
any harm will come.  I suspect the over system Z will now be determined by the midrange. 

Good luck.
Logged

Offline schwarcw

  • Ready For Intervention!
  • ******
  • Posts: 1625
  • Karma: +0/-0
  • No one here gets out alive!
Re: 3 way crossover with 2 speakers
« Reply #3 on: September 18, 2015, 09:56:04 PM »
Should not be an issue, give it a try!
Logged
Carl

Offline scorpio333

  • Ready For Intervention!
  • ******
  • Posts: 1182
  • Karma: +0/-0
  • got mule?
Re: 3 way crossover with 2 speakers
« Reply #4 on: September 19, 2015, 10:25:23 AM »
So far, so good.
Logged
Pages: [1]   Go Up
« previous next »