Repair / Help Forum > Repair / Help

Dual 721 lever

<< < (2/3) > >>

scorpio333:

--- Quote from: RuralTom on June 24, 2016, 06:13:57 PM ---!4 miles?  Can you go pick it up?

--- End quote ---

I haven't been able to verify anything...it appears the site is run by TD Enterprises which is located on S Craig St. That may be the operational address and the warehouse could be anywhere. They haven't replied to an email I sent asking about picking up.

After listening to the table for a few hours last night I'm going to order the part. Even with the crazy shipping cost, I'm still way under what I'd expect to pay for one of these tables in good working condition.

Sir Thrift-a-Lot:
Since you have most of it in tact, couldn't BJ whip you one up with his 3D printer?

scorpio333:
Dualparts got back to me, they had a bug in the calculator. Shipping is $6 so I just ordered it. In the meantime I might try and whip up a better looking plinth for it to live in. Since it's a direct drive, mass won't matter much so I'm just goi g to make a drop in shell for the whole thing to live in.

scorpio333:
Ordered the lever Monday, arrived yesterday. Sent from a PO box in Pittsburgh, so they are located here in the Burgh. Nice to know there's a quick parts stash close by. That's the good. The not so good was the packaging. It was sent in a small USPS box and wasn't even sealed. Inside were three green Post Gazette bags for filler. The part was in a baggie inside one of the rolled up PG bags. It arrived intact, but not how I would of packed it. Now that lever is in, it's on to fixing that damn steuerpimpel that plagues all these old automatic Duals.

gdv:
Glad it came so quick!  Glad it was not damaged...

Rescue that 721!   :P


Good job,
George

Navigation

[0] Message Index

[#] Next page

[*] Previous page