Audio Discussion > DIY
Speaker level to line level converter box
BB3:
Jesus Christ Ron Is That Impressive. I Sure Wish That I Had Your Knowledge And Skills.
Excellent Work Ron. Oh ! And Did I Mention How Impressive It Is ???? WOW !
Take Care Ron.---------BILL(BB3)
Kingman:
Is this a version of the Carver Z-1 coupler???
rgpit:
--- Quote from: Kingman on January 27, 2010, 07:40:51 PM ---Is this a version of the Carver Z-1 coupler???
--- End quote ---
Not sure what the Z-1 is. Here is the circuit that I used. It is a simple 10:1 voltage divider circuit.
MasterBlaster:
Ron,
Just curious...
The schematic calls for 10k and 1k resistors.
Why'd you use 100k and 10k?
I would expect that would seriously lower the output levels.
/Al
rgpit:
--- Quote from: Master Blaster on January 27, 2010, 08:19:14 PM ---Ron,
Just curious...
The schematic calls for 10k and 1k resistors.
Why'd you use 100k and 10k?
I would expect that would seriously lower the output levels.
/Al
--- End quote ---
Oops!...good eye Al. That was a typo. I actually used 10k and 1k. (I edited the original post and put in the correct values)
Navigation
[0] Message Index
[*] Previous page
Go to full version