Repair / Help Forum > Repair / Help

Technics SL-Q210 and Rotel RA-311

(1/1)

JamezDee:
Hey guys,

I recently bought a Technics SL-Q210 turntable to use with my Rotel RA-311.

The turntable plays with no issues when I heard it at the seller’s place, however I have been unable to make the sound clean (noise on the channel) and it’s nowhere near as loud as using my iPhone as the input source.

Currently it’s connected to the phono input, although I think the ceramic input would be the better option? (Phono works without any issues with my iPhone as the input source)

Any ideas on how I can get a cleaner and louder sound?

EmperorNorton:
Can you try the turntable on another receiver, or use an separate phono preamp into a non-phono input on the Rotel ?   I'd also check the wiring on the cart.

Jim Pittsburgh:
Have you rebalanced the turntable and checked the tone arm settings?     You didn't say what cartridge the new tt has, but I seriously doubt it is ceramic. Those were used on inexpensive tts back in the 50s -60s -70s  and do not have the required  RIAA curve if memory serves...  I could be wrong on that , but I don't think so


Also,  the lower volume in phono is due to the output of the cartridge. The term they use is "gain".  to equalize the two sources, since you are not using a HT receiver,  will require either a step up unit or a separate phono pre that has that feature.

But before you buy anything, make sure that all the settings on the tonearm are correct.

Sir Thrift-a-Lot:
The ceramic input is not the correct one.   That is a magnetic cartridge.   As you seem to be new to vinyl my first question is did you connect the ground wire?   Lots of people who didn't grow up with records don't realize there are three connections to be made, not just two.

Sir Thrift-a-Lot:
Oh, and don't be alarmed if your phone sounds louder.   It's a very hot output.   Once you get the table functioning correctly, turn the volume on the phone down to meet that level.   You'll get cleaner reproduction with more dynamic range.

Navigation

[0] Message Index

Go to full version