Repair / Help Forum > Repair / Help

Cerwin Vega DJ set up

<< < (3/3)

JohnO:
Thank You
I was not sure on where out of the mixer and was reading more into it than required.
Looking at the mixer board and seeing how the different sections are located ole grey is starting to sop it up.
I hate to, but assume one uses the program slide on the mixer for volume with the amp output/volume set at a nominal, speaker save level?
The other input jack sizes were messing with me too as the speakers require 1/4 plugs at the cabinet and I didn't think they would convert from 1/4 inch to RCA to go into the program output at the mixer.
Thanks again for the assist.
I will take a run at it and let you know.
JohnO

MacGeek:
I cannot clearly tell from the pic of the back of the amp, but suggest checking the a/c input voltage setting.  It looks like it might be in the 240 volt position.

Sir Thrift-a-Lot:

--- Quote from: MacGeek on June 22, 2021, 08:51:46 AM ---I cannot clearly tell from the pic of the back of the amp, but suggest checking the a/c input voltage setting.  It looks like it might be in the 240 volt position.

--- End quote ---

Good eye, but it looks to me like it's locked at the 120 position with a switch guard and screws.    Definitely worth double checking.

JohnO:
Yes it is secure in the 120V selection.
I finally got a chance to plug it in.
The neighbors for about 4 blocks round got a good listen on Canada Day.
Although the Pouges aren't Canadian this Irishman is and they got their share of Shane MacGowan.
I did play lots of Neil Young and Randy Bachman as well as The Guess Who, April Wine, The Stampeders and Steppenwolf.
I even played some Buffy Sainte-Marie for our Indigenous brothers.
Thanks for the help guys everyone enjoyed it.
JohnO

Navigation

[0] Message Index

[*] Previous page