Audio Discussion > TUBES TUBES TUBES

Dynaco ST70 - new to me

(1/4) > >>

bmwr75:
Bought this amp from an AKer.  Its had an upgraded driver board and cap board installed.  Have mated it up with a Dynaco PAS2 preamp and Dynaco A-35 speakers.  New production tubes are installed: four JJ KT77, two JJ EC802S (12AU7), and one Tung Sol 12AX7.  Sounds good.  

Am already wondering about rolling some NOS tubes in.  Any suggestions??

OCCD:
Very nice pick up! ;D

NATOE:
6p3s-e look for quad of these. good new old stock tube. 

don't for get to check the bias on that.

NATOE:
Just looking at that it looks like a solid state rectifier if it is I would be leery of a stock quad cap in there.

bmwr75:
Natoe,

The quad cap is just for looks, a new cap board has been installed.  Checked and adjusted the bias first thing out of the box.  I actually have two quads of NOS 6P3SE tubes that were purchased from eBay Sergy in Russia.  Can't beat them for $35/quad delivered.

Thanks,
Scott

Navigation

[0] Message Index

[#] Next page