Repair / Help Forum > Repair / Help

Are the handle attachments removable on Carver gear?

(1/2) > >>

paden501:
Hey all.

I'm stuck between a rock and a hard place at the moment.  We're furnishing my stereo room and the entertainment center we picked out won't properly fit my Carver CT-17 and SD/A-450.  The width of both those pieces is 19" and I only have 18.125" in the cabinets.  So I'm wondering if the metal piece that the handles bolt to is removable.  I know that I can just remove the handles themselves, but I need to also remove the metal trim that they bolt to in order to make it fit.

Is that possible?  If not, I fear there may be some carver equipment on the market here soon.   :'(

Falcon:
Sell the rack, NOT the Carver gear....

thuffman03:
The rack ears on both of those cannot be removed.

I am with falcon377, sell the racks and keep the Carver.  Another option you can give them to me.  I will go out and buy a rack that they will fit in ;D

But if you must sell the gear check with OCCD.  I know he has some Adcom items that I think will fit.  He has preamps and cd players.  All are very nice and are just about as good as the Carver IMO.

http://vintagehifipgh.com/index.php?main_page=product_info&cPath=45_48&products_id=167
http://vintagehifipgh.com/index.php?main_page=product_info&cPath=17&products_id=143

Call Tom and have him double check to see the width of these.  I am sure he can do a trade in on your Carver.

OCCD:
SCREW THAT RACK!!!  However, there are other preamps you can use. CT-  26v 27v  28v  29v.  The only CD without rack handles is the DTL-50 and the SD/A-360 handles can be removed. The 360 will give you the same sound as your 450.

 ;D

BB3:

--- Quote from: paden501 on December 01, 2009, 10:35:00 PM ---Hey all.

I'm stuck between a rock and a hard place at the moment.  We're furnishing my stereo room and the entertainment center we picked out won't properly fit my Carver CT-17 and SD/A-450.  The width of both those pieces is 19" and I only have 18.125" in the cabinets.  So I'm wondering if the metal piece that the handles bolt to is removable.  I know that I can just remove the handles themselves, but I need to also remove the metal trim that they bolt to in order to make it fit.

Is that possible?  If not, I fear there may be some carver equipment on the market here soon.   :'(

--- End quote ---

Don't Do It Matt. :'(-----Get A Different Rack. hehehehe-------BILL

Navigation

[0] Message Index

[#] Next page

Go to full version