Vintage HiFi Audio Forum

Audio Discussion => General Discussion => Topic started by: Reverend on July 15, 2010, 06:51:34 PM

Title: Luxman PX-101
Post by: Reverend on July 15, 2010, 06:51:34 PM
Picked up a luxman linear turntable for cheap until I can fix my Acoustic Research XA.  I was surprised at the weight of the thing.  It came with a Stanton cartridge which doesn't have any markings but I've seen them before.  A ball with a brush hanging off the front of it.  All and all it sounds pretty damn good.  Might invest in a new cart but should be a keeper. 
Title: Re: Luxman PX-101
Post by: MasterBlaster on July 15, 2010, 06:59:07 PM
Very nice looking unit.
Title: Re: Luxman PX-101
Post by: Kingman on July 15, 2010, 09:07:36 PM
NICE!!!!...If you decide to move it on, pm me!!!!  8) 8) 8) 8)
Title: Re: Luxman PX-101
Post by: OCCD on July 15, 2010, 10:27:50 PM
Quote from: Kingman on July 15, 2010, 09:07:36 PM
NICE!!!!...If you decide to move it on, pm me!!!!  8) 8) 8) 8)

I can deliver it to you Kingman. ;)
Title: Re: Luxman PX-101
Post by: SunnyDaze on July 16, 2010, 01:00:37 AM
VERY nice.
Title: Re: Luxman PX-101
Post by: Kingman on July 16, 2010, 07:16:30 AM
Quote from: OCCD on July 15, 2010, 10:27:50 PM
Quote from: Kingman on July 15, 2010, 09:07:36 PM
NICE!!!!...If you decide to move it on, pm me!!!!  8) 8) 8) 8)

I can deliver it to you Kingman. ;)
SWEET!!!!!...bringing me a pair of ALIII's too?????  :-*
Title: Re: Luxman PX-101
Post by: Reverend on July 16, 2010, 12:24:16 PM
Found a replacement needle for the cart, that should make a big improvement as it looks a little worse for wear.  I really like this table.  Very smooth operation.  The arm weight is made out of a solid block of aluminum.  Sounds fantastic.  Sorry Kingman, this might be a keeper.
Title: Re: Luxman PX-101
Post by: Kingman on July 17, 2010, 08:55:51 AM
Quote from: RevAmish on July 16, 2010, 12:24:16 PM
Found a replacement needle for the cart, that should make a big improvement as it looks a little worse for wear.  I really like this table.  Very smooth operation.  The arm weight is made out of a solid block of aluminum.  Sounds fantastic.  Sorry Kingman, this might be a keeper.
...I understand Rev...I always liked the look of the linear tables. Do you have the top for it?