Vintage HiFi Audio Forum

Audio Discussion => General Discussion => Topic started by: Sir Thrift-a-Lot on March 25, 2017, 04:33:12 PM

Title: Do any of you guys have an angle grinder?
Post by: Sir Thrift-a-Lot on March 25, 2017, 04:33:12 PM

I'm going to need to cut a piece of steel threaded rod to length AND flatten one side of it for about an inch.   I think this would be the easiest way to get it done.   Thanks in advance.

Title: Re: Do any of you guys have an angle grinder?
Post by: MacGeek on March 26, 2017, 09:32:23 AM

Not sure what your project is.....I have a bench grinder and 90 degree hand held grinder, if that can work; Dremel tools well.  Also a large collection of hand files.  Something should work.  I am home today.

Title: Re: Do any of you guys have an angle grinder?
Post by: Sir Thrift-a-Lot on March 26, 2017, 03:33:53 PM

Thanks Mac.   I haven't ordered the parts yet.   One of the four Rock Solid speakers I ordered had it's stand snapped off in shipping.   Seller is going to try to obtain another stand, but if he is unsuccessful this will be a plan B.