« previous next »
Pages: [1]   Go Down

Author Topic: How to strip tonearm wire>?  (Read 3705 times)

Offline Slim-Shaddy

  • CARVER KILLER!!!
  • ******
  • Posts: 1555
  • Karma: +0/-0
  • Tubes are for boobs
    • This is Bullshit
How to strip tonearm wire>?
« on: January 29, 2012, 02:09:00 PM »
While working on repairing a Pioneer PL-530 I snapped a tonearm wire while trying to strip it. I'm obviously a novice and I tried to gently pull off the insulation with my thumb nail. Wrong idea I guess. I'm going to order new wire and I don't want to make the same mistake again. Please advise!! :o :o
Logged
I am confident that an SL-1200 is capable of outperforming turntables of much higher expense with minor modification.

Offline Reverend

  • Ready For Intervention!
  • ******
  • Posts: 2162
  • Karma: +0/-0
Re: How to strip tonearm wire>?
« Reply #1 on: January 29, 2012, 02:49:48 PM »
Since I'm the king of breaking tonearm wires  :P the way I strip the insulation might not be the best or correct way but it works well for me.  I have a little hand held butane torch and will burn the sleeving off.  You have to make sure to lightly sand/clean up the end that is burnt afterwards.
Logged

Offline Slim-Shaddy

  • CARVER KILLER!!!
  • ******
  • Posts: 1555
  • Karma: +0/-0
  • Tubes are for boobs
    • This is Bullshit
Re: How to strip tonearm wire>?
« Reply #2 on: January 29, 2012, 11:56:01 PM »
Thanks rev, I'll give that a shot once I order and receive the wire.
Logged
I am confident that an SL-1200 is capable of outperforming turntables of much higher expense with minor modification.
Pages: [1]   Go Up
« previous next »