Author Topic: Advent Legacy woofer original?  (Read 5156 times)

Offline EmperorNorton

  • Zen Master
  • *****
  • Posts: 706
  • Karma: +1/-1
Advent Legacy woofer original?
« on: July 13, 2014, 09:41:27 AM »
Can anyone tell me if this looks like original Advent woofer?  Or can I ID it if I remove and see a serial number on rear of speaker?  thanks
Rega Planar 3
WTL TPP
Oppo 103
Musical Fidelity M1 DAC
AR LS-17
Quad II 80 monoblocks
Canton CT-800 speakers

Offline ESM

  • Double Secret Probation!
  • **
  • Posts: 178
  • Karma: +0/-0
Re: Advent Legacy woofer original?
« Reply #1 on: July 13, 2014, 10:36:02 AM »
You should be able to id it by the numbers written on the speaker.  That rust looks suspect. .

Offline EmperorNorton

  • Zen Master
  • *****
  • Posts: 706
  • Karma: +1/-1
Re: Advent Legacy woofer original?
« Reply #2 on: July 13, 2014, 01:08:05 PM »
Pulled both woofers and they are the same part number 15152278.   They both had what looked like a little red spray paint on the magnet.  Maybe that would be from Advent quality control?   I had them hooked up and they sound pretty nice.  Naturally would prefer that they are all original parts.  The cabinets are beat and will be my first refinish job and one of the grills had cat damage and will need replaced.
Rega Planar 3
WTL TPP
Oppo 103
Musical Fidelity M1 DAC
AR LS-17
Quad II 80 monoblocks
Canton CT-800 speakers

Offline Sir Thrift-a-Lot

  • Ready For Intervention!
  • ******
  • Posts: 3813
  • Karma: +1/-0
Re: Advent Legacy woofer original?
« Reply #3 on: July 13, 2014, 02:03:45 PM »
If it were me, I would pull the gaskets and lift the foam, hit that rust with a Dremel and some black Rust Oleum.

Offline Sir Thrift-a-Lot

  • Ready For Intervention!
  • ******
  • Posts: 3813
  • Karma: +1/-0
Re: Advent Legacy woofer original?
« Reply #4 on: July 13, 2014, 02:04:23 PM »
I'd also lose the screws and install some proper t-nuts.

Offline gdv

  • Audio Connoisseur
  • ****
  • Posts: 625
  • Karma: +0/-0
Re: Advent Legacy woofer original?
« Reply #5 on: July 13, 2014, 10:15:41 PM »
Emp...  From my memory, those are NOT the original Advent Legacy woofers...

See link below, but the original had foam surrounds and had "ribbing" near the outer edge as the photo link below shows...

http://www.ebay.com/itm/Advent-Legacy-Woofers-Need-Refoam-/121368538401?pt=Vintage_Electronics_R2&hash=item1c4220ed21

5 out of 4 people have trouble with fractions...

Offline Sir Thrift-a-Lot

  • Ready For Intervention!
  • ******
  • Posts: 3813
  • Karma: +1/-0
Re: Advent Legacy woofer original?
« Reply #6 on: July 13, 2014, 10:39:58 PM »
Plus, they only have four bolt holes instead of eight.   Good eye, gdv.

Dicky

  • Guest
Re: Advent Legacy woofer original?
« Reply #7 on: July 13, 2014, 11:10:25 PM »
That sort of looks like a Bose woofer to me.  I recall a set of 301's I redid with that flat spot in the middle of the dust cap, and leads through the cone.

SunnyDaze

  • Guest
Re: Advent Legacy woofer original?
« Reply #8 on: July 14, 2014, 12:45:17 AM »
Can anyone tell me if this looks like original Advent woofer? 

Those may be original woofers from an older model Advent, but, they are not Legacy woofers.

I had a set of Legacy II's - The drivers had a few sets of "rings" toward the outer perimeter of the cone. Additionally the dust covers were very thin and fully convex. Legacy III's are similar. Legacy I's, I'm not 100% sure of, but doing photo searches on Legacy I's does not turn up a woofer similar to what you've got.

Offline gdv

  • Audio Connoisseur
  • ****
  • Posts: 625
  • Karma: +0/-0
Re: Advent Legacy woofer original?
« Reply #9 on: July 14, 2014, 09:25:53 AM »
I agree with Dicky that it looks like a Blose woofer, BUT Emp's has a rubber surround & Blose had foams...
5 out of 4 people have trouble with fractions...

Dicky

  • Guest
Re: Advent Legacy woofer original?
« Reply #10 on: July 14, 2014, 10:16:37 AM »
I couldn't see that they were rubber... Yes Bose would never do something so smart