Repair / Help Forum > Repair / Help
Connecting Vintage Pioneer gear
Detroit313:
Looking for some help. I have a vintage pioneer SX 980 receiver and sg 9800 EQ. Looking for the best way to connect them. I have tried big it just goes not seen right. I get hissing in the speakers when it is on. I think I am connecting it wrong. Any suggestions ?
Sir Thrift-a-Lot:
"I have tried big"?
MacGeek:
Some pics of the front and rear panels will be helpful
Detroit313:
Sorry...that would probably help :) See attached. Connecting right to the receiver through the Tape Loop but just not sound right. Trying to make sure i have it hooked up right through that but I have also been told that I could hook it up directly to the pre amp connections as well. A bit confused to the right way that sounds good. I don't want to damage anything. A bit of a newbie here with this.
Detroit313:
Sorry about the typos in the original post. Was trying to do this on my phone....unsuccessfully...
Navigation
[0] Message Index
[#] Next page
Go to full version