Repair / Help Forum > Repair / Help

Connecting Vintage Pioneer gear

<< < (2/2)

Sir Thrift-a-Lot:
Equalizer output to receiver Tape 1 play.   Equalizer input to receiver Tape 1 record.

If that isn't sounding right perhaps you have switches or pots that need to be cleaned.   Also snap a pic of your EQ front when it is being used but not sounding right.   It's surprisingly easy to make things sound awful with a bad EQ curve.

MacGeek:
Is there any objectionable hiss when listening to your sources with out the eq installed?  Has the hiss level with nothing connected changed lately?  This is a vintage receiver that might need service (as is the eq).

Otherwise, a hiss problem might be caused by an impedance mismatch, although that should be unlikely with two components from the same manufacturer and of the same vintage.  As an aid to diagnosing the problem, I suggest trying to patch the eq between the pre-out main-in loop on the receiver (receiver pre out to eq in, followed by eq out to main in on receiver).

While using this arrangement is generally not preferred when other options are available (such as the one referenced by STaL), the voltage going to the eq will vary depending on the volume setting of the receiver, which in turn may affect the level of hiss, or eliminate it.

Good luck and let us know how it goes.

Detroit313:
Connected the proper way but still have hissing from the connection.  Going to try and clean them but might have to get it serviced unless there is something I am missing that would cause it.  I tried connecting to each the tape 1 and tape 2 and it still does it which tells me that it is the connector on the EQ that might be the problem.  Let me know if you have any other suggestions.  Thanks to you both for the help.

Sir Thrift-a-Lot:

--- Quote from: Sir Thrift-a-Lot on July 07, 2022, 10:09:57 PM ---  Also snap a pic of your EQ front when it is being used but not sounding right.   It's surprisingly easy to make things sound awful with a bad EQ curve.

--- End quote ---

quaddriver:
This is a straightforward loop hook up.  Do not use the pre-out/main in as you need to carefully match levels and its a good way to pop an amp that is getting harder to fix.

can you loop it to something else to look for problems in the SG?

Navigation

[0] Message Index

[*] Previous page

Go to full version