Audio Discussion > DIY

Dynaco rebuild

<< < (2/3) > >>

NATOE:
That was a nice feeling to have when al got to see what i had done to his amp what it was to where it is now.
Would like to pass it on if anybody has some old tube gear that needs work done just drop a line or let al or tom know. pref dynaco

MasterBlaster:
Thanks again Pete for your fine restoration work.
I can hardly wait until Saturday.  We'll be featuring it at the club meeting. :D

schwarcw:
Looks outstanding!  And you know, it's the little things.  Look at the twisted wires to help reduce potential noise.    The new improved IC board also adds to the noise reduction.  It should sound excellent!  I'm looking forward to hearing it!

Regards,

Carl

OCCD:
The Pre will be done tomorrow and ready to go Saturday as well.

MasterBlaster:
Well, Yesterday's feature of the Dynaco gear at the shop was a blast!
OCCD tested all the tubes and found that the 7199's had very little life and
provided replacements. Thanks Tom!

Everything performed beautifully, and sounded just incredible.
I cant say this enough either - NATOE did a wonderful restoration job;
I couldn't be more pleased with his work. I could not have done this without him!


I havent yet decided where I'm going to put the gear, but I just
had to get another taste.

I excitedly hooked everything up today on the dining table and it was
every bit as impressive at home with the Jamo Towers. Now i've got
to find it a permanent home.


I couldn't resist taking some long exposure pics to capture the glow!  ;D
Not too bad for a dinky little sanyo camera!

[smg id=72]

[smg id=73]

Navigation

[0] Message Index

[#] Next page

[*] Previous page