« previous next »
Pages: [1]   Go Down

Author Topic: APC J10 600W Conditioner/UPS - $149 @ vanns.com  (Read 6417 times)

Offline MasterBlaster

  • Administrator
  • *****
  • Posts: 1100
  • Karma: +0/-0
    • Vintage HiFi of Pittsburgh
APC J10 600W Conditioner/UPS - $149 @ vanns.com
« on: August 28, 2010, 12:45:30 AM »
Folks,

Just noticed this was on sale at VANNs.
APC J10

Thoughts?


Logged
HT: Audiocontrol Maestro M3, Sunfire 5*200,  Tannoy Mercury MX , SVS PB-12 Sub

Head-Fi: FUBAR IV Plus DAC, Grado SR225

Living Room: Dynaco ST-70 (R&R work done by NATOE), Dynaco PAS Preamp, Jamo C607 towers, MCS 6710 Turntable

Offline thuffman03

  • Zen Master
  • *****
  • Posts: 1097
  • Karma: +0/-0
  • CarverFest Evictee
Re: APC J10 600W Conditioner/UPS - $149 @ vanns.com
« Reply #1 on: August 28, 2010, 08:43:48 AM »
Looking at the specs of the J type series I would not buy for high end audio.  Would be good for video and computers.

Waveform Type Stepped approximation to a sinewave

You should look for power conditioners that are a full sinewave.  They normally start near the $1k mark.
Logged
Got Carver?

Offline Turtle

  • Basshole!
  • ******
  • Posts: 58
  • Karma: +0/-0
Re: APC J10 600W Conditioner/UPS - $149 @ vanns.com
« Reply #2 on: August 28, 2010, 04:46:05 PM »
I think the H series work better for audio and home theater.  I have both the H10 and H15 and they work very well.  I think the H10 was a stereophile recommended component.
Logged
When I die I hope my wife doesn't sell my stuff for what I told her I paid for it.

Marantz SA15S2/Rega P3, Parasound P3, Parasound A21, Monitor Audio RS6
Pages: [1]   Go Up
« previous next »